Digital input/output (DIO)

LogicPool (DIO)

This module supports several hardware expansions cards or submodules, no all functionalities are supported for all submodules.

Models

There is only one model for this module.

CBUS Address

Supported hardware

SU700, SU701, SU703, SU704, SU706, SU707

Register Map

Module Address: 'T' or Ox??

Read register

Read registers

Register Address	Name	Data
0	MUX_IN	Bit 7..0: multiplexer address
1	STATE_IN	Bit 7..0: input value

Write register

Write registers

Register Address	Name	Data
0	MUX_OUT	Bit 7..0: multiplexer address
1	Debounce	Bit 7..0: input value
2	Mode	Bit 0: '1' 50 Ohm termination '0' Open Bit 1: NIM/TTL '1' NIM '0' TTL

LabVIEW Vi

Digital Input/Output. Support: SU700, SU701, SU703, SU704, SU706, SU707 According to hardware this supports either TTL,, TTL_coax, NIM or DIFFERENTIAL I/Os. Each connector can be used as either an output (DO) or input (DI) or both. If used as an input, terminal DO (driving output) must not be connected, as this enables the output driver and would override any input signals.

Please obey termination rules as defined for the specific used hardware!

Inputs

DIO#: number of connector (must be unique!)

Outputs

USB In and USB Out are related to the selected USB interface! No connection uses a global parameter, set by OPEN.vi!

Parameters

Mode: set according to used hardware module and level standards.

(SU704 supports switchable 50 Ohm termination!)

Debounce/ms: debounce delay for suppressing intermittent signals (1..255 ms). debounce=0 disables this function!

Functions

 Connect: 	connects all in/outputs and sets all parameters
 Set DO: 	change input DO
 Get DI: 	return output state at DI
 Write Mode: load appr. mode

LabVIEW demos

SU_DIO_Test.vi