SU748
Contents
Description
This module provides a super speed USB3.0 Interface for the LogicBox in association with the Cypress FX3 USB3.0 controller. Due to the 32-Bit parallel Data-BUS, the submdoule was designed as a double SU-Board with two SU-Connectors. The hole board can be supplied by the +5V-supply of the USB-Port or the +5V-supply of the LogicBox. To protect the FX3 controller against a faulty VBUS voltage from the USB-Port, the USB charger port protection chip TPD4S014 was used. The FX3-Chip provides several serial interfaces like I²S, I²C, SPI and UART to connect to external peripherals. With the implemented I²C register PCA9555 configured by I²C or the 8-Pin DIP-Switch, some status information can be displayed on eight LEDs at the frontpanel.
Block Diagram
Front panel
Version 0
Back Connector
Version 0
SU7XX pin table (direction shown for the SU board!)
power in +5V 2 1 +5V in power
NC - - 4 3 - - NC
NC - - 6 5 - - NC
NC - - 8 7 - - NC
NC - - 10 9 - - NC
NC - - 12 11 - - NC
NC - - 14 13 - - NC
NC - - 16 15 - - NC
NC - - 18 17 - - NC
NC - - 20 19 - - NC
LVTTL out SDIN 22 21 - - NC
LVTTL in SCLK 24 23 - - NC
LVTTL in CSn 26 25 - - NC
LVTTL in SDOUT 28 27 - - NC
NC - - 30 29 - - NC
NC - - 32 31 - - NC
NC - - 34 33 - - NC
power in GND 36 35 GND in power
Power consumption
Version 0
+5V -> XX mA
-5V -> XX mA
Measurement
Version 0
Compatibility
This module is compatible with all base boards
